Using STing and Cab etc on Falcon

[Bikerbob]

Hey, if you have followed, I am trying to use the picoW wifi adapter on a falcon (STOCK)

I have got it working with picoW and UIPserver - can see it and communicate from other computers on network.

With STing - I can ping computers on network and can ping outside computers with ip address

I think I am having DNS issues. I can ping 8.8.8.8 no issues - but I cannot successfully traceroute to it.

SYSinfo in tools shows everything connected and working.

Cab will not resolve the DNS - I have tried both Dan A and other fellows Cab-ovl.

So driver is USBether - address is set, general is USBnetwork and mac address is there.

Default config has nameserver = 192.168.0.1(my router) and router.tab is 0.0.0.0 tab 0.0.0.0 tab USBether tab 192.168.0.1

Any ideas?

James

[jd]

Default config has nameserver = 192.168.0.1(my router) and router.tab is

0.0.0.0 tab 0.0.0.0 tab USBether tab 192.168.0.1

try NAMESERVER= 8.8.8.8, 192.168.0.1

Is USBether exactly what you see in Sting port Setup CPX Addressing > when you select device comms port? as names must exactly match (case too)

Failing that post pics of Sting Internals and both Addressing and General page of Sting Port Setup cpx's.

[Bikerbob]

ok, Ill get back to you. thanks for responding.