Hades and ROMPort

[Kroll]

Hi,

I would like ask about ROMPort,
From the beginning in my Hades is installed on the ISA connector ROMPORT, please look at the poor quality, if you need I can to make better.

Photo-0152.jpg

Photo-0153.jpg

Do you know what is connected to one of the ports?

I have still a problem to instal Realtek 8139 and that's why I wanted to ask you
Is it possible to connect a NETUSBEE card (network card) that I am using to the Internet at Atari Falcon and TT
If so, how do I put it in because it probably inserted bad can damage, card or ROMPORT?

[beel1]

It looks like a dongle for music software: http://reho.st/http://www.nightfallcrew ... G_9830.jpg

[frank.lukas]

Year a Dongle ...

The card has original three romports I think and to switch between the ports you need a pice of Software.

Which way to put the Modules in measure who is GND and who +5V and compare it with a 520/1040/Mega ST ...

[Kroll]

It looks like a dongle for music software: http://reho.st/http://www.nightfallcrew ... G_9830.jpg

Someone tell me what soft used this, it is some key

ROMPORT.jpg

I made much better a photo and I have other question someone knows what is 40 pin connector (look like is IDE connnector) ?

[Kroll]

Year a Dongle ...

The card has original three romports I think and to switch between the ports you need a pice of Software.

Yes it is true, I can activate one of the ports with a special accessory HADES_B * .ACC and I have the choice of either none or A, B, C

Which way to put the Modules in measure who is GND and who +5V and compare it with a 520/1040/Mega ST ...

OK thanks I see

[gstoll]

poor quality, if you need I can to make better.

Can you do this. On my card there are some modification on both sides near the ISA connector. At the moment I am not sure if that card is for the Milan.

If so, how do I put it in because it probably inserted bad can damage, card or ROMPORT?

I upload here picture from the card I have. There is a label on each connector (oben = above). You need also the accessory to select one of the three.

[Kroll]

Can you do this. On my card there are some modification on both sides near the ISA connector. At the moment I am not sure if that card is for the Milan.

I will send some photos via e-mail

I upload here picture from the card I have. There is a label on each connector (oben = above). You need also the accessory to select one of the three.

And now I have some problems with choice of ROMPORT. In accesory Hades_B3.ACC in single TOS is OK, but I dont know why, under MiNT when always open the accesorium there is none, I can not set A, B or C.

[frank.lukas]

Without the Hades_B3.ACC the Port "A" should be aktiv ?

[Kroll]

Without the Hades_B3.ACC the Port "A" should be aktiv ?

In my ROMPort card the romport 1 connector is not soldered (please look at), romport 2 is empty in 3 I dont know what.

Photo-0080a.jpg

I dont know how to check what is active if no loaded Hades_B3.ACC ?

[gstoll]

And now I have some problems with choice of ROMPORT. In accesory Hades_B3.ACC in single TOS is OK, but I dont know why, under MiNT when always open the accesorium there is none, I can not set A, B or C.

In the archive Hadessh.zip is the latest version. Maybe it works better.
http://www.medusacomputer.com/thes-download.html