wanted : any old TT boards NW

Do you need some hardware and/or software? Do you want to clear out the attic? Post your classified ads here. Please use the sub forum if you are posting links to items you've found on ebay.

Moderators: Mug UK, Adrenalin, Moderator Team

Post Reply
Guest

wanted : any old TT boards NW

Post by Guest »

price payed flat rate £50 + shipping for a non working rev d-k board {soldered on 68030}
all ic's must be present
User avatar
frank.lukas
Hardware Guru
Hardware Guru
Posts: 2165
Joined: Tue Jan 29, 2008 5:33 pm
Location: Germany

Re: wanted : any old TT boards NW

Post by frank.lukas »

ebay 121210979146

without Ajax and no SCSI Chip, Pins faulty under the SCSI Chip, no TOS
fancy Atari Musik anDA Dance "Agare Hinu Harukana" 1998 ATARI http://www.youtube.com/watch?v=JX10fxb5eYE
Guest

Re: wanted : any old TT boards NW

Post by Guest »

got that

my max bid in 100 euros

and thats that its worth it for the ic's too me only
perhaps its just a simple thing

bagadge battles for sure

my max bid is 100 euros and thats out

the board is worth a 100 euros to anyone who needs the chips for sure
Guest

Re: wanted : any old TT boards NW

Post by Guest »

if anyone needs funnel ic's i found a source in the hk will supply me with 10 off
so i have 6 just now

trying to restore old board at the best prices
replace the ram and funnel and mcu at the same time
prices for 10 off of ic's C XXXXX numbers atari are good you can find most at 10 off price
hk and china are keen to get rid of them
so cut there price
i got 10 funnels for 40$ + tax and post about $90p
$40 is NOT acceptable !!!
and ic 's like TT funnels should be about $10 inc post
Guest

Re: wanted : any old TT boards NW

Post by Guest »

if the ram fails in the TT the funnels do also fail
User avatar
frank.lukas
Hardware Guru
Hardware Guru
Posts: 2165
Joined: Tue Jan 29, 2008 5:33 pm
Location: Germany

Re: wanted : any old TT boards NW

Post by frank.lukas »

… this is a fake Auction just to pull out the money out of your pocket !
fancy Atari Musik anDA Dance "Agare Hinu Harukana" 1998 ATARI http://www.youtube.com/watch?v=JX10fxb5eYE
Dal
Administrator
Administrator
Posts: 4205
Joined: Tue Jan 18, 2011 12:31 am
Location: Cheltenham, UK
Contact:

Re: wanted : any old TT boards NW

Post by Dal »

How did you find this out?
STE: Desktopper case, IDE interface, UltraSatan (8GB + 512Mb) + HXC floppy emulator. Plus some STE's/STFM's
User avatar
frank.lukas
Hardware Guru
Hardware Guru
Posts: 2165
Joined: Tue Jan 29, 2008 5:33 pm
Location: Germany

Re: wanted : any old TT boards NW

Post by frank.lukas »

Everyone knows what simbo Offers ...

I think, it's not that much worth !
fancy Atari Musik anDA Dance "Agare Hinu Harukana" 1998 ATARI http://www.youtube.com/watch?v=JX10fxb5eYE
Guest

Re: wanted : any old TT boards NW

Post by Guest »

well i got it for 82 euros i also got three atari mice

so i think it will be around 100 euros in total

anyway as long as the funnel ic and memory is ok i can repair anything else
like ajax etc and place a socket over the scsi pads and repair them ive got some ajax ic and also the scsi -2 type controller

if it boots after i fit a set of tos ic's and check out other bits
to a logo im happy
Guest

Re: wanted : any old TT boards NW

Post by Guest »

well it arrived i did pay 80 quid or so + post but it was worth it
i overworked the plcc scsi pads to remove the rubbish and any shorts
so i added some roms and a new reset button
and it booted to gibberish
press the mcu and power up bing it booted

so i hot aired the pins on the mcu right the way round with some flux liquid added first

and as if by magic it boots fine all the way to the desktop

so i need to patch in some pins thats pads had been lifted off etc
ill finish the scsi chip later
its nice to see the machine at least boot to logo without it fitted
ill place a tips section for how it was fixed
check out the rather bad pic of whats before i start too add a new socket etc

anyway out with the snipers for the socket base so i can get at the connection that are gone
some glue and a bit of very thin copper wire
You do not have the required permissions to view the files attached to this post.
Post Reply

Return to “For sale / Wanted”