wongck wrote:Mmm.... ok, I didn't know that.
I am using a KVM for the video, I monitor the CTCPI ATI debug and then switch over to the DVI port.
May be I keep it all the way on the DVI port without switching.
However, on VGA it works. May be DVI is different.
paul92706 wrote:I would love to know more about this too, i also only get VGA working and not DVI.
Ektus wrote:I've had one card that would output VGA but no DVI. Another card (same brand, same layout, no visible difference) works for both ports. It may be just a matter of the card's BIOS, or a faulty device.
mfro wrote:It's a little different than I thought: if port 1 is VGA and port 2 is DVI (as it is the case for most of my ATI cards), DVI (port 2) is only used if there is *no* monitor detected on port 1.
I would assume a standard KVM will report a "fake" monitor connected on any port, so you probably should try and completely disconnect your VGA port.
paul92706 wrote:What kinda cable did you use? Was it just a standard DVI to DVI cable?
wongck wrote:paul92706 wrote:What kinda cable did you use? Was it just a standard DVI to DVI cable?
Yup, just standard DVI-DVI cables. Nothing special.
Rustynutt wrote:Confused wongck. Is your DVI out working without the KVM and VGA D/Q'ed?
wongck wrote:Rustynutt wrote:Confused wongck. Is your DVI out working without the KVM and VGA D/Q'ed?
It does not work with the KVM ( which is a VGA only KVM). I have not a DVI KVM.
So it's straight from my ATI card to the LCD.
Finally, I get 1920x1080 from my Falcon
I wonder why using VGA, it does not show this resolution. Need to google why.
Users browsing this forum: No registered users and 4 guests