willy wrote:I need to rethink that once again, or just make 2 different kits:
- One for them who don't want to modify case (no additional holes etc)
- And another one for those who may accept some holes.
joska wrote:willy wrote:Why not have the DVI connector on a separate board, with a cable to a simple header on the SV? Then the user can decide for himself where to mount the connector.
Personally I would not consider a solution that requires a molested case.
willy wrote:But, I want to do that smart, and fulfill requirements of them who Do Not Want make any holes in falcon case, and them who did it already, and doesn't care about few more holes.
jvas wrote:Can't the DVI be replaced by HDMI? Lot smaller.
Users browsing this forum: No registered users and 2 guests