yungjoon wrote:The corrupted display screenshot I joined in this thread was in 030 mode. In 060 mode I get a black screen.
Yesterday, my Falcon/CT63 did some strange artifacts or lines on the screen.
I shut it down and after, It didn't boot, black screen but disk spinning.
I tried to boot it in 030 mode and got a messed screen (see picture) with crash. I tried several reboots and got crashes at different level (ex.:when loading hddriver, NVDI, when mounting cdrom, ...)
When I try to boot in 060 mode, I allways get black screen.
I suspect it is nvram problem but I am not sure. What is the best way to reset it ?
I tried free030 (boot from floppy I created with my 1040 STe) but It didn't solve the problem.
Any idea ?
DarkLord wrote:Its good to see you on here Rodolphe.
yungjoon wrote:Hi all,
This week-end, I reseated CT board, ST-RAM board, cleaned ram pins, checked PSU voltage.
In 030 mode: no more display artifacts, I have to perform more tests to check system stability.
In 060 mode: After the ram check, the system always crashes when loading /auto programs (something like what I see on the picture I joined here), I need to stop ram checking at boot and there is no problem, It passes /auto programs loading. I tried to load cubase, ace midi, It seems to be ok, but I need also to perform more tests.
Something strange, in 060 mode, the CT does not boot at power up. I need to do a reset.
I did some test at boot (CNTRL+ALT+SHIFT R+SHIFT L): dsp, os, ram, display ... many of them failed. Is something dying ?
Users browsing this forum: No registered users and 5 guests