acsi wrote:OK so my CF card has died and I've lost everything.
So how do I partition the new CF card and what do I need?
Is it a 500MB Fat16 partition and the balance a Ext2 partition for MINT?
acsi wrote:OK Now I'm just a bit annoyed.
It will only just boot then start failing. First the file system fails (SD and CF) then the mouse starts moving slowly for about 3 seconds and stops. After which everything halts (Except for the display which still shows fine).
Emails to Mathias fail to send adding to further frustration. I believe he was unwell recently so I hope he did recover?
Anyone have any ideas on how to reach him as this is a series 2 board it should be under warranty. Or does someone want to buy a Atari styled Blue Brick?
acsi wrote:Also as a side note after re flashing I have sound and the Fuji logo is back when booting
acsi wrote:The card is toast as far as I can tell. Gparted wont access it at all.
The replacement card was working but has failed after half an hour. I need to check it tomorrow but I think my firebee may be eating cf cards or I’m just having bad luck.
Users browsing this forum: No registered users and 5 guests