On my Falcon doesn't work. Crash said could be related with some mod (SCSI clock mod) I have on my Falcon
The installation instructions says "If you get only noise and the spectrum display id maxed then close it and try again (sync problems were reported)". Well I closed and tried again several times, even rebooting the Atari, but the only thing I get is the spectrum display id maxed.
Well this was one of the main issue I had with my Falcon those days and the cause of stopping my projects. This problem came more often each day until it was impossible for me to continue working with it.
My suspiction is that there may be a sync problem between the Audio Matrix and the DSP. If the Spectrum is maxed out, it would mean that the communication between the DSP and the GUI still works but that the audio serial data may be out of sync (shifted). As this issue came with the time it may be just a capacitor which value was near the specified limit and due to aging got out of spec.
I hope someone gets a solution for this.
Regarding Voxx I have bad news: My original Falcon hard disk which I have in my hands now, doesn't work any more. When I turn it on (attached to a USB interface) it starts to rotate for about 5 seconds and then stops. after a while it tries to start again and the procedure repeats again and again. The heads of the HD doesn't seem to get in action so there may be fault in the initialization....
Just in case that someone has an idea or it is an known issue, here the HD data:
Brand: CONNER Peripherials