Bikerbob wrote:I appreciate the link to the MonSTer page, but info there is a little scetchy. SO the MonSTer board is 1. IDE interface for 2 drives? 2. Flash TOS holder for up to 4 images, and 3. 8mb of Ram that can be used at TT ALT ram.
Four drives, but otherwise correct
But please note that there are some limitations to alt-RAM on the MSTE. Due to the VME address range you can't have more than 10Mb RAM (normal + alt) on the MSTE.
Bikerbob wrote:So - on an STF or STE can they also access this ram? Does HDDriver work with this ide interface?
Yes and yes.
Bikerbob wrote:There are a number of "jumpers" refered to.. I assume pin jumpers? So to make any changes I have to open up the machine and get to this?
You will usually connect some switches to these jumpers, allowing you to switch TOS etc without opening the case.
Bikerbob wrote:I also see no install instructions on the site.. does this plug into a cpu socket and then the cpu goes in the board?
Bikerbob wrote:Or Maybe a better question is there a MonSTer thread anywhere?? or other souces for info??