Hi there, I'm having problems getting my ESP-01 to work with the firmware. I have it wired up and working using other firmware (namely a WIFI232 type firmware, but when i try and program it using the two bin files from your site: 0x00000.bin and 0x10000. I am not having much luck, even communicating to it via usb on my laptop (which is normally not a problem) or my atari. Blue light flashes a lot and it just spits out junk..
"Symptoms of missing init data can be endless reboot loops of the ESP8266 and possibly wildly flashing LEDs on the module."
but mine has had working firmware put on it before... I must be doing something wrong just not sure what... if I were to add the esp_init_data_default.bin, what address would I program it to, based on the info in the programming window below?
Here is the unit i built:
I am using on of those usb to esp-01 modules to program it, and I added a program switch and reset switch.
i have several ESP-01 modules, and even upgraded one to 4Mbytes.
using this program software, with 0x00000 and 0x10000
is it possible to put the two files together so I can just program at 0x00000?
after trying this firmware, I was still able to go back to the WIFI232 type firmware via arduino IDE, so pretty sure my boot loader is still ok.
any help appreciated.
You do not have the required permissions to view the files attached to this post.