alanh wrote:Have some TOS only drivers underway.
This will support mass storage and Ethernet. I'll write a STiNG driver.
alanh wrote:Hi busybee,
I'm going to do a small run of about 10 units with the 3D printed case. All parts are ordered, so I just need to solder and test when the bits & bobs are in, and so I think the price with be about 40UK pounds, plus shipping on top. Obviously no ACSI cables are needed, so no extra cost there.
The FreeMiNT mass storage drivers and ethernet are working. But I haven't had much time on the TOS drivers yet.
As for hardware support. It works with all Atari's which have an ACSI port, so that means ST, STE, MegaST, MegaSTE, TT, and the reason I did this is for my Medusa T40 which also has an ACSI port.
Performance varies with the machine as it's the Atari that has the USB stack loaded.
alanh wrote:Yes. All the source code will be available, and most of it already is. The FreeMiNT hardware driver is already in the FreeMiNT repository.
alanh wrote:I think it'd be about 10UKP to 12UKP based on previous experience.
alanh wrote:I'll have a brief order page up at
when it's ready for ordering.
Thanks for the interest.
Users browsing this forum: No registered users and 14 guests