Page 1 of 1

F030 - No drives found even if device detected

Posted: Wed Mar 07, 2018 10:00 am
by whiskey
I finally managed to connect my cosmo to my falcon via a SCSI enclosure (took my a year to get hold of a suitable cable/enclosure combo). HDDriver detects both SD and CE_DD devices on the SCSI bus, but there is no drive shown/detected, even though the SD card was formated/partitioned and is fully operational on a MegaST (in ACSI mode, of course). I've tried changing the IDs for both SD and CE_DD to different values to no avail, results identical.
The drives on the internal IDE HDD are of course detected by HDDriver and fully operational.
Any ideas? What am I missing/doing wrong?
falcon_cosmo_hddriver_resize.jpg

Re: F030 - No drives found even if device detected

Posted: Fri Mar 23, 2018 1:26 pm
by nanard
and are you seeing translated drives when CEDD driver is loaded ?

Re: F030 - No drives found even if device detected

Posted: Sat Mar 31, 2018 2:23 pm
by whiskey
nanard wrote:and are you seeing translated drives when CEDD driver is loaded ?

bought an external SCSI enclosure with built-in power supply (instead of the 0.75A mobile phone charger I used before) and voila, works like a charm :cheers:
Got my internal IDE/CF, SD in cosmo and a network drive on my NAS via cosmo all working at the same time, reading & writing happily. I'm now getting worried about running out of drive letters in TOS :lol:

Re: F030 - No drives found even if device detected

Posted: Sat Mar 31, 2018 2:45 pm
by dhedberg
Yes, the CosmosEx with the RPi requires more juice than 0.75A. I initially tried using a 1A power supply but even that wasn't enough. 1.6A did the trick.

Re: F030 - No drives found even if device detected

Posted: Sun Apr 01, 2018 1:44 am
by Bikerbob
Agreed. I use a 2A USB charging adaptor, to the usb input and working great.