Hi! first thanks a lot for this great device! I never used an Atari ST on the 80s (jumped directly form the C128 to an XT), so I'm learing about it these days. I finally managed to get CosmosEx running on my Atari 1040 STF, TOS 1.04.
I manage to load images in the 3 floppy slots with the CE_FDD.PRG program from O drive. I select one image with the CosmoEx button, and the try to open the Floppy. I get the message "Data on the disk in drive A may be damaged". I tried with many ST images, even with the ST files supplied with the PDDriver, and always get the same message. Also tried floppy B, the same.
However, if I reset and boot from A (Reset and press the A button), if I open the Floppy I can see and run the contents of the floppy.
I have the defaulta settings in CE_Config. I tried changing some of them, but with no luck so far..
I would appreciate any ideas on what I might be doing wrong, or if this could be a hardware / software problem. Or even if this is the expected behaviour!
Thanks a lot!