TXG/MNX wrote:Now it works fine when IKBD is connected to the MegaSTE with the original keyboard plugged in aswell. But when I remove the original MegaSTE kbd from the IKBD And i start the Atari its ok but when I press a key it looks/sounds like a key is stuck on the keyboard. Is there a fix for this?
TXG/MNX wrote:Thanx because i need this for all my mega-st(e) and tt systems...
Maybe a dummy plug on the keyboard side?
HuggyOne76 wrote:Problem is the same with a standard STE. That was one of my first test.
Now, since I've got the good DMA chip, I only have problems with few softwares where the mouse stay in the upper left corner...
TXG/MNX wrote:@jookie did you find a solution yet for use without kbd connected ?
TXG/MNX wrote:Ok pin 1+2+4 ? When i look at the picture? I will make me a plug for now
DrCoolZic wrote:I guess this could be done on a regular st when do not want to use KB?
I am asking question because I am thinking to just take a ST motherboard out of the Atari box and do a system with CosmosEx + MB in a different box ?
DrCoolZic wrote:no with above explanation I can figure it out
DrCoolZic wrote:by the way I have an STE board which is probably one of the latest produced with more compact DMA Ajax chip etc...
I got the board alone and it boots but the KB/Mouse does not work.
As this is a brabd new board I would be surprise it is broken?
Do you know if the KB on latest latest STE was using a different protocol? So that an old KB would not work on this new board?
Users browsing this forum: No registered users and 2 guests