mahen wrote:Regarding LEDs, do you think this item would do the trick (as I have no out-of-order A1200 to get the pieces from) : http://amigakit.leamancomputing.com/cat ... cts_id=564 [unfortunately this item is NOT in stock but maybe it can be found somewhere else]
I guess one could find an out-of-order A1200 somewhere instead...
mahen wrote:As I said earlier, I pre-ordered the new A1200 cases from Philippe Lang that look super sexy and have mount points for an A1200, a Raspberry, a MiST and a Keyrah. Apart from that, all the rest has to be taken care of (ports, sd card access, leds...).
SuperBabyHix wrote:If I could ask a question, what is the reason for using a SCART to HDMI converter instead of a VGA to HDMI converter? I assume this is not using the MiST's built in scan doubler. Is there an advantage? Does it perhaps have less flicker in the interlaced modes?
Sorgelig you are the greatest ! If this will be available I sure will buy one. Keep up the great work. I also hope to see more updates on cores from you."I'm planing to make my own scaler on FPGA. So, it will be able to handle high range of video from PAL to real VGA modes and output to HDMI"
Sorgelig wrote:Standard PAL resolution.
Non-PAL and Non-NTSC modes require special scaler.
I'm looking for a good scaler. If i will find it, then i can try higher resolutions.. Otherwise i will have to make my own scaler which will require a lot of effort..
Sorgelig wrote:For those, who are going to put MiST inside A1200 case: you HAVE TO use US layout keyboard!
There won't be change in FW for other layouts because those 2 empty keys have important usage in MiST as a special keys.
Users browsing this forum: No registered users and 5 guests