joska wrote:I have a similar experience with my Firebee, where 1920x1080 does not work on most (*all* except one actually) of my monitors. The problem in that case is wrong sync polarity. I doubt that is the case here, but I would not be surprised if there was a compatibility-issue with the SV's 1920x1080 and your particular monitor. Maybe you should try another monitor.
shoggoth wrote:IIRC 1920x1080 requires the use of reduced blanking, which is ok on digital DVI, but not always on analag VGA monitors. It’s likely to be a timing issue, methinks.
mikro wrote:shoggoth wrote:IIRC 1920x1080 requires the use of reduced blanking, which is ok on digital DVI, but not always on analag VGA monitors. It’s likely to be a timing issue, methinks.
As expected, another SuperVidel (and even another Falcon) produces the same results (quite an experience to take out the SV out of storage after so many years, it still had FW004!), on DVI-D of course.
From what I could read from SV's history log, there used to be timing issues for other resolutions as well (1600x1200 IIRC), any chance you could guys take a look at that? I assume it's a FW issue rather than SV_XBIOS one?
mikro wrote:I'm going to try FW11 (when my JTAG USB cable arrives)
Users browsing this forum: No registered users and 5 guests