Hi folks,
finally a new, well NOS, CT63 made it to me and I checked out my SV sitting around here for some month. Setting up the SV was pretty straight forward and plug&play. I managed to get nice resolutions up to 1280x1024 with 16 colors. This is my LCDs native resolution. But when increasing color depth to 256 or even 65k I get garbage output on the screen (see picture).
Setup:
CT63 running fine@95Mhz (factory setting), ABE/SDR v7
512 MB Kingston SDRAM
SuperVidel v2, default SV.INF
No bus boost
No other extensions
14 MB Ramcard by Lynxman
PicoPSU 80w
What I've tried:
- CT63 Boot flash version 2.00, 2.01, 1.03c
- Different monitors
- VGA/DVI output
- Plain TOS (only SV Driver in AUTO Folder)
- NVDI 5 with SV supplied ASSIGN.SYS and drivers
This is not getting better... Any thoughts where to search or what to try else? Perhaps it is important: At boot the ATARI - Logo from CT63 screen is not shown correctly at SV output, on Videl Output everything is fine.
Additional question: How do I get ST-LOW running with the SV? When I switch to ST-LOW, I always get a "Frequency out of band" on different monitors (LCD/CRT)
Thanks for any input!
Cheers
Johannes